You're currently running a old version of Internet Explorer. Due to security and much newer technology, please upgrade or replace your browser.
We currently support Internet Explorer 9+, but we highly recommend you install
Please notify your IT department if you need assistance.
DESVM6020 mounting kit brackets are designed to mount "active" DPF systems vertically, utilizing steel isolation springs for filter base and outlet section.
DESVM6020 mounting kit brackets can also mount the SC35 "passive" DPF system, this requires the purchase of a special inlet hat with a base plate (CDTi part # C22-0626).
Cross bar support utilizes rubber isolators
Constructed and welded using mild steel.
All parts are powder coated black.
All hardware (hex bolts, flat washers, nylock nuts) are yellow zinc chromate, grade 8 (included).
Brackets must be assembled as shown and hardware torqued to **listed standards, FAILURE TO DO SO MAY CAUSE DAMAGE TO THE "DPF" SYSTEM OR INJURY TO PERSONS.
Tighten the (2) upper mounting band isolation spring hardware to the bottom of threads on bolt. This ensures proper compression of spring for optimum isolation.
DO NOT tighten isolation spring hardware to the listed torque specifications! Reasonable care should be taken when tightening, to ensure equal compression and avoid excessive compression of the isolator springs.
After filter and guard are installed, ensure the DPF system does not obstruct or impair the drivers use of the mirrors.
**TORQUE SPECIFICATIONS: 3/8-16 GRADE 8 (40-50 ft lbs.)
7/16-14 GRADE 8 (60-75 ft lbs.) 1/2-13 GRADE 8 (90-110 ft lbs.)